Omschrijving
The Challenger RP2040 NFC is a small embedded computer, equipped with an advanced on-board NFC controller (NXP PN7150), in the popular Adafruit Feather form factor. It is based on an RP2040 microcontroller chip from the Raspberry Pi Foundation which is a dual-core Cortex-M0 that can run on a clock up to 133 MHz.
NFC
The PN7150 is a full featured NFC controller solution with integrated firmware and NCI interface designed for contactless communication at 13.56 MHz. It is fully compatible with NFC forum requirements and is greatly designed based on learnings from previous NXP NFC device generation. It is the ideal solution for rapidly integrating NFC technology in any application, especially small embedded systems reducing Bill of Material (BOM).
The integrated design with full NFC forum compliancy gives the user all the following features:
- Embedded NFC firmware providing all NFC protocols as pre-integrated feature.
- Direct connection to the main host or microcontroller, by I²C-bus physical and NCI protocol.
- Ultra-low power consumption in polling loop mode.
- Highly efficient integrated power management unit (PMU) allowing direct supply from a battery.
Specifications
| Microcontroller | RP2040 from Raspberry Pi (133 MHz dual-core Cortex-M0) |
| SPI | One SPI channels configured |
| I²C | Two I²C channel configured (dedicated I²C for the PN7150) |
| UART | One UART channel configured |
| Analog inputs | 4 analog input channels |
| NFC module | PN7150 from NXP |
| Flash memory | 8 MB, 133 MHz |
| SRAM memory | 264 KB (divided into 6 banks) |
| USB 2.0 controller | Up to 12 MBit/s full speed (integrated USB 1.1 PHY) |
| JST Battery connector | 2.0 mm pitch |
| On board LiPo charger | 450 mA standard charge current |
| Dimensions | 51 x 23 x 3,2 mm |
| Weight | 9 g |
Note: Antenna is not included.
Downloads
